1¡¢How to use light in this situation at the intersection?
A¡¢turn off high beam lights
B¡¢use hazard lights
C¡¢use the high and low beam lights alternately
D¡¢use high beam lights
Answer£ºC
2¡¢When following a vehicle on the road, the distance from the vehicle in front is not important. As long as the driver goes forward at the same speed as the vehicle in front does, he can avoid rear-end collision.
A¡¢Right
B¡¢Wrong
Answer£ºB
3¡¢What marking is the combination of the white broken lines and the triangle area?
A¡¢road entry marking
B¡¢lane-dividing line that can be crossed
C¡¢deceleration line at road entry
D¡¢road exit marking
Answer£ºA
4¡¢Whats the meaning of the double yellow solid lines?
A¡¢opposite direction lanes dividing line that can not be crossed
B¡¢opposite direction lanes dividing line that can be crossed
C¡¢bilateral same direction lanes dividing line that can be crossed
D¡¢one-way lanes dividing line
Answer£ºA
5¡¢It lights to indicate that ______
A¡¢the hazard lights flash
B¡¢right-turn signal flashes
C¡¢left-turn signal flashes
D¡¢front and rear width lights flash
Answer£ºA
6¡¢Whats the meaning of this sign?
A¡¢stop to yield
B¡¢one-way road
C¡¢going first when crossing each other
D¡¢the opposite vehicle goes first when crossing each other
Answer£ºC
7¡¢You should speed up to go through the railway crossing in this case.
A¡¢Right
B¡¢Wrong
Answer£ºB
8¡¢ABS system can maximize the braking efficiency when conducting _______
A¡¢braking intermittently
B¡¢braking continuously
C¡¢applying emergency braking
D¡¢gently depressing the brake pedal
Answer£ºC
9¡¢Whats the meaning of this sign?
A¡¢minimum speed limit is 50km/hr
B¡¢maximum speed limit is 50km/hr
C¡¢the height is 50m
D¡¢the altitude is 50m
Answer£ºA
10¡¢When driving during the period of probation, the driver should paste or hang _____ on the rear part of the vehicle
A¡¢a mark of avoiding with care
B¡¢a mark of paying attention of beginner
C¡¢a uniform probation mark
D¡¢a mark of paying attention of vehicle distance
Answer£ºC
11¡¢In which situation cannot overtake a vehicle in front?
A¡¢vehicle in front is reducing speed to yield
B¡¢vehicle in front is turning left
C¡¢vehicle in front is pulling over by the roadside
D¡¢vehicle in front is turning right
Answer£ºB
12¡¢When a tire blows out suddenly on the road, the driver should refrain from violently depressing the brake pedal in panic. Instead, he should try his best to shift the gear to a low position and use the engine braking to reduce the speed of the vehicle.
A¡¢Right
B¡¢Wrong
Answer£ºA
13¡¢Whats the meaning of the double white broken lines in far front of the intersection?
A¡¢waiting to run line
B¡¢stopping and yield line
C¡¢slowdown and yield line
D¡¢left-turn waiting line
Answer£ºC
14¡¢What is this manipulation device?
A¡¢switch of the turn signal
B¡¢switch of the head lights
C¡¢switch of wiper
D¡¢switch of defogger
Answer£ºD
15¡¢When encountering a traffic jam on the expressway, the driver should follow the front vehicle lining up, and immediately turn on the hazard light to prevent rear-end collision.
A¡¢Right
B¡¢Wrong
Answer£ºA
16¡¢When encountering slow-moving vehicles at an intersection that has no traffic signals, the motorized vehicle should pass alternately.
A¡¢Right
B¡¢Wrong
Answer£ºA
17¡¢It lights to indicate that ______
A¡¢engine compartment is opened
B¡¢cover of fuel tank is opened
C¡¢doors of both sides are opened
D¡¢luggage compartment is opened
Answer£ºC
18¡¢If the applicant commits bribery or cheating in the course of a test, his eligibility for this test will be cancelled and the results of other tests he has passed will be invalid.
A¡¢Right
B¡¢Wrong
Answer£ºA
19¡¢If a motorized vehicle runs 50% faster than the specified speed limit, the driver is subject to a 3-point penalty.
A¡¢Right
B¡¢Wrong
Answer£ºB
20¡¢How to use lights at this position?
A¡¢turn on the right-turn signal
B¡¢turn on the left-turn signal
C¡¢turn on the hazard lights
D¡¢turn on the head lights
Answer£ºB