1¡¢Which is the wrong measure to avoid tire burst?

A¡¢Reduce tire pressure

B¡¢Check tires regularly

C¡¢Remove foreign matters from the tire tread grooves timely

D¡¢Replace tires that have cracks or deep cuts

Answer£ºA

2¡¢The sign on the right warns of a road section ahead under construction.

A¡¢Right

B¡¢Wrong

Answer£ºA

3¡¢The sign on the right indicates a passing bay ahead.

A¡¢Right

B¡¢Wrong

Answer£ºA

4¡¢The sign on the right indicates that turning right is not permitted at the intersection ahead.

A¡¢Right

B¡¢Wrong

Answer£ºA

5¡¢The sign on the right indicates to stop and yield for oncoming vehicles approaching on the road ahead.

A¡¢Right

B¡¢Wrong

Answer£ºB

6¡¢The sign on the right indicates the road width ahead is limited to 3 meters.

A¡¢Right

B¡¢Wrong

Answer£ºA

7¡¢The sign on the right warns of an abrupt slope section ahead.

A¡¢Right

B¡¢Wrong

Answer£ºA

8¡¢When a motor vehicle catches fire, the driver should swiftly turn off the engine and open the hood to extinguish the fire.

A¡¢Right

B¡¢Wrong

Answer£ºB

9¡¢What should the driver do to ensure the motor vehicle passes the level crossing safely?

A¡¢Change to neutral gear and slide over

B¡¢Stop, look, and pass

C¡¢Speed up, look and pass rapidly

D¡¢Slow down, look and pass slowly

Answer£ºC

10¡¢When approaching a vehicle on a narrow slope, which one of the following ways is correct?

A¡¢The descending vehicle yields to the ascending

B¡¢The vehicle which is further from the slope crest should yield

C¡¢The ascending vehicle yields to the descending

D¡¢If the descending vehicle has reached the midpoint while the ascending vehicle has not yet set out, the descending vehicle must yield.

Answer£ºA

11¡¢What should motor vehicle drivers do when approaching an oncoming vehicle on a frozen road?

A¡¢Cut speed as approaching each other

B¡¢Pass each other by speeding up properly

C¡¢Pass each other slowly by cutting speed in advance

D¡¢Pass each other along the central line to the best

Answer£ºC

12¡¢What should a driver do before entering a tunnel on an expressway

A¡¢Turn on the high-beam

B¡¢Turn on the width lamp and the tail lamp

C¡¢Turn on the low-beam

D¡¢Sound the horn before entering the tunnel

Answer£ºC

13¡¢The white zig-zag line on the highway serves as a reference for the speed of a driver.

A¡¢Right

B¡¢Wrong

Answer£ºB

14¡¢When driving on a muddy road, what should the driver do?

A¡¢Try to avoid using the foot brake

B¡¢Drive slowly in mid or low gear

C¡¢Firmly hold the steering wheel

D¡¢Speed up and pass through

Answer£ºABC

15¡¢The sign on the right indicates that the vehicle should yield to the oncoming traffic as approaching each other.

A¡¢Right

B¡¢Wrong

Answer£ºB

16¡¢Drivers may cross these lane-dividing lines to change lanes in the same direction.

A¡¢Right

B¡¢Wrong

Answer£ºB

17¡¢Under such circumstances, what should motor vehicle drivers do?

A¡¢Continuously sound the horn

B¡¢Pass quickly

C¡¢Pass at a lower speed

D¡¢Bypass from either side

Answer£ºC

18¡¢The sign above the tunnel indicates a height limit of 3.5 meters on the road ahead.

A¡¢Right

B¡¢Wrong

Answer£ºA

19¡¢When the tire pressure is too low, what can happen when driving at a high speed?

A¡¢Tire pressure will be unstable

B¡¢Tire pressure will increase

C¡¢Driving resistance will decrease

D¡¢The tire will burst

Answer£ºD

20¡¢After speeding up to more than 60 km/hour, a motor vehicle driver may drive onto the driving lane directly.

A¡¢Right

B¡¢Wrong

Answer£ºB

View the complete version of the question bank
Ïà¹Ø¼Ý¿¼Ó¢ÎÄÊÔÌâ Ô˳ǿ¼¼ÝÕÕÓ¢ÎÄÊÔÌâ ÉØ¹ØÓ¢Óï¿ÆÄ¿ËÄ¿¼ÊÔ ÑŰ²¼ÝÕÕ¿¼ÊÔÓ¢ÎİæÍøÕ¾ ´óͬӢÎÄ¿ÆÄ¿ËÄ¿¼ÊÔ ½­Î÷½»Í¨·¨¹æÓ¢ÎĽ»¹æÌâ¿â ¼ÝУ¿¼ÊÔÓ¢ÎÄÌâ¿â´óÈ«´ð°¸ ³üÖݼݿ¼Ó¢Óï°æ¿ÆÄ¿ËÄ ÌúÁë¿ÆÄ¿ËÄÄ£Ä⿼ÊÔÓ¢ÎÄ°æ ¸§Ë³Ó¢Óï¿ÆÄ¿ËÄÊÔÌâºÍ´ð°¸ ãòÖÝÓ¢Îİæ¼ÝÕÕ¿¼ÊÔÌâ¿â